3D printer - Velleman K8200

From ipswichmakerspace
Revision as of 14:13, 16 June 2019 by Kellis (Talk | contribs) (Category added)

Jump to: navigation, search

Velleman K8200

K82003dprinter.jpg

The Velleman K8200 is an opensource RepRap printer, also sold under the 3Drag name. This printer is connected to a Raspberry Pi with OctoPrint installed. To use, plug the 3d printer and Raspberry Pi into the mains and switch on, after a minute or so the Raspberry Pi will launch the webbased OctoPi control software. Connect your computer to the Makerspace wifi and point your web browser at http://192.168.1.20.

Specification

Build volume: 200mm x 200mm x 200mm
Filament diameter: 1.75mm
Nozzle diameter: 0.4mm
Filament types Most, but prefers PLA
Max hotend temperature: 275 deg. C
Max bed temperature: 80 deg. C
Hotend Genuine E3D all metal hotend
Extruder Genuine E3D Titan extruder
  • Magic numbers for Layer heights, use these for best quality:
0.100 mm
0.150 mm
0.175 mm
0.200 mm
0.225 mm
0.250 mm
0.275 mm
0.300 mm
0.325 mm

The Firmware has recently (20/12/2018) been updated to Marlin 1.1.9 with thermal runaway protection enabled. Certain constraints have been limited in firmware

  • Maximum hot end temperature is 275 deg.C
  • Maximum bed temperature is 80 deg.C
  • Thermal runaway is now enabled

Velleman K8200 web site


Current Issues

  • There is a small firmware issues at present, on large Z moves the firmware will halt and the printer control board will need resetting. During the print everything seems okay. Therefore before starting a print get the Z axis near home. If the board resets turn the printer off and on again (not OctoPrint) re-connect Octoprint and carry on. I will investigate and rectify soon (KE).
  • I have made a couple of changes in firmware
  1. Enable the 'noisy' endstop feature, this should prevent the error on Z homing.
  2. Turned off thermal runaway on the bed heater (thermal runaway is still enabled on the hotend), this will prevent thermal runaway kicking in during a print.

I tested for several hours and did not run into any further firmware resets. Please let me know if you encounter any. KE.

Upgrade Plans

Todo
  • Look at Z nut, currently has a lot of backlash Complete, but Z flexible coupler needs replacing, new one is on order
  • Install new power supply - This is the next upgrade required, current power supply cannot keep the bed up to temperature - ordered.
  • Install RAMPS control board
  • Install new belts and tighten properly
  • Consider installing second Z lead screw and motor
  • Consider upgrading heated bed
Complete
  • New Easy Peelsy magnetic bed surface has been installed. Please do not use scrapers on it. Clean with Isopropanol before using.
  • Install new E3D hotend and direct drive Titan extruder for 1.75mm filament