Difference between revisions of "October 6th Working Party"

Latest revision as of 21:03, 6 October 2018

Priority Tasks

• Sort and clean the workshop.
• Sort out the corner by the door [part done]
• Clean the kitchen
• Clean the toilet
• Hoover the main room floor
• Sort out the electronic benches
• Take rubbish to the tip [part done]
• The Laser PSU needs properly attaching, and the new Air Assist Control System (TM) needs installing

Other Tasks

• Set up a network shared folder. Common software, learning resources, and other critical stuff (like games) could live there.
• Get the vinyl cutter working - some software has arrived, testing is needed.
• The PCs need some tinkering again; PC3/Centre (nearest grey cupboard) seems to only output VGA (or the monitor ignores DVI). It might be a BIOS setting issue; ignore the top graphics ports!
• PC2/Back (middle of the 3 PCs) seems to overscan; likely either graphics settings or monitor issue, but nothing obvious. DVI use may fix it.
• Attach air conditioner outlet into Mr Laserducky's enclosure.
• Patch up Woodzilla front pockets. They've split out from the frame at the base.
• Swap front door camera.
• Fix concerningly squeaky workshop hatch.
• Fix leaky Turnigy extruder
• We've had some donations of Misc Stuff In Boxes. Currently at the top right of Palletron, they need sorting and curating/defenestrating as required.
• Tile the kitchen wall above the sink
• Paint more of the ceiling - this is a condition of our lease.